Finishing options > 49
W
INDOWS
PCL
1. In the driver’s Setup tab, recall any saved driver settings you may wish to use.
2. Choose Booklet from the Finishing Mode drop-down list, then click Options.
3. In the Options window you can set the signature size (see page 48, the number of
pages per side of paper and the bind margin if your document is going to be thick.
The graphic in this window shows the effect of each choice you make.
NOTE
If the Booklet choice is not shown, check that the Duplex option is enabled in
the driver. (See “Setting the driver device options” on page 12.)
To Next Page
Loading...
