e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING June 2004 © TOSHIBA TEC
5 - 66
[Procedure 4]
Is the staple/fold motor clock sensor (PI14) working properly?
#
NO Replace the sensor.
YES
Does the staple/fold motor operate at the appropriate timing?
#
YES Replace the finisher controller PC board.
NO
Is the saddle stitch unit drive mechanism working properly?
#
NO Fix the mechanism.
YES
Try replacing the staple/fold motor (M7). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
[CB60] Stapler unit shift motor abnormality
MJ-1025
Is the slide home position sensor (PI18) working properly?
#
NO Replace the sensor controller PC board.
YES
Is the wiring between the finisher controller PC board and slide motor correct?
#
NO Correct the wiring.
YES
Is there any mechanical problem with the stapler stand motion path?
#
YES Fix the mechanism.
NO
Try replacing the slide motor (M8). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
