e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DRIVE SYSTEM
9 - 16
Note:
Reassemble the registration clutch so as to
match the end of the shaft with that of the
clutch as shown in the right-hand figure.
Fig. 9-28
(16) Disconnect 1 connector, remove 2 screws,
and take off the bracket.
Fig. 9-29
(17) Loosen 1 setscrew, take off the upper trans-
port clutch (High speed) with the gear.
Note:
Do not mix up the registration clutch and
upper transport clutch (High speed) when
installing them.
Fig. 9-30
0
Bracket
Connector
Setscrew
Gear
Upper transport
clutch (High speed)
To Next Page
Loading...
