e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 14
[A-7] Bypass paper sensor (S35)
(1) Take off the bypass feed upper cover
( P.10-12 "[A-4] Bypass feed upper
cover").
(2) Remove 4 screws and take off the upper
plate.
Fig. 10-22
(3) Take off the sensor arm.
Fig. 10-23
(4) Disconnect the connector from the sensor
and release the latch to take off the bypass
paper sensor.
Fig. 10-24
Upper plate
Sensor arm
Bypass paper sensor
To Next Page
Loading...
