12
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
DEVELOPER UNIT
12 - 19
(6) Remove 3 screws and take off the rear
cover.
Fig. 12-23
(7) Front side: Remove the following parts
installed on the shaft of the developer sleeve
in order: Bushing, collar, roller (bearing-1), E-
ring, bearing-2 and oil seal.
* Procedure for replacing an oil seal:
P.12-32 "Fig. 12-63 "
Fig. 12-24
(8) Rear side: Remove the following parts
installed on the shaft of the developer sleeve
in order: E-ring, bushing, collar, roller (bear-
ing-1), E-ring, gear, pin, bearing-2 and oil
seal.
Fig. 12-25
Screw
Screw
Rear cover
To Next Page
Loading...
