Toshiba e-studio281c - Page 290

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPER UNIT
12 - 20
[A-6] Mixer
(9) Take off the developer sleeve.
* Procedure for replacing an oil seal:
 P.12-32 "Fig. 12-63 "
Fig. 12-26
(1) Discharge the developer material
( P.12-16 "[A-2] Developer material").
(2) Take off the developer sleeve
( P.12-18 "[A-5] Developer sleeve").
(3) Front side: Remove the following parts
installed on the shaft of each mixer in order:
E-ring, bushing-1 and bushing-2.
* Procedure for replacing an oil seal:
 P.12-32 "Fig. 12-63 "
Fig. 12-27
(4) Rear side: Remove the following parts
installed on the shaft of each mixer in order:
E-ring, gear, bearing and oil seal.
* Procedure for replacing an oil seal:
 P.12-32 "Fig. 12-63 "
Fig. 12-28
Developer sleeve
Bushing-2
Bushing-1
E-ring
E-ring
Gear
E-ring