Toshiba e-studio281c - 3.5.13 Beam level conversion setting; 3.5.14 Maximum toner density adjustment to paper type; 3.7.11 Reproduction ratio of primary scanning direction (black); 3.7.12 Reproduction ratio of primary scanning direction (color)

To Next Page

To Previous Page

REVOLVER UNIT

13 - 11

[F] Revolver unit

(1) Take off all of the color developer units

( P.12-21 "[B] Color developer unit").

(2) Take off the process unit ( P. 11 - 1 0 " [ B ]

Process unit").

(3) Take off the left inner cover ( P. 11 - 2 3 " [ P ]

Temperature/humidity sensor (S19)").

(4) Take off the left rear cover

( P.2-29 "[M] Left rear cover").

(5) Take off the color auto-toner sensor

( P.12-31 "[F] Color auto-toner sensor

(S10) / Color auto-toner sensor shutter sole-

noid (SOL1)").

(6) Take off the color toner cartridge sensor

( P.13-8 "[A] Color toner cartridge sensor

(S9)").

(7) Take off the internal cooling fan

( P.13-8 "[B] Internal cooling fan (M20)").

(8) Take off the revolver home position sensor

( P.13-9 "[C] Revolver home position sen-

sor (S8)").

(9) Take off the laser optical unit ( P.8 - 11 " [ A ]

Laser optical unit").

(10) Release 2 latches take off the laser cooling

duct cover (rear side).

Fig. 13-12

(11) Pull out the handle. Remove 2 screws and

take off the laser cooling duct cover (front

side).

Fig. 13-13

Laser cooling duct cover (rear side)

Laser cooling duct cover (front side)

Other manuals for Toshiba e-studio281c