14
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
TRANSFER UNIT
14 - 15
[H] Transfer belt cleaner auger motor (M2)
[I] 2nd transfer roller
(1) Take off the process unit
( P.11-10 "[B] Process unit").
(2) Disconnect 1 connector and remove 1 har-
ness clamp itself.
(3) Remove 2 screws and take off the transfer
belt cleaner auger motor with its bracket.
Fig. 14-24
(4) Remove 2 screws and take off the transfer
belt cleaner auger motor from its bracket.
Fig. 14-25
(1) Open the 2nd transfer unit.
(2) Remove 1 clip, 1 collar (with bearing), 1
washer and 1 bushing (with bearing) on the
front side of the 2nd transfer roller.
(3) Remove 1 clip and slide 1 bushing (with
bearing) on the rear side of the 2nd transfer
roller.
(4) Take off the 2nd transfer roller.
Fig. 14-26
Transfer belt cleaner
auger motor
To Next Page
Loading...
