16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 25
[F] Fuser belt
(1) Take off the fuser roller
( P.16-23 "[E] Fuser roller / Fuser belt
guide").
(2) Lift up the fuser belt unit and take it off.
Note:
Be careful not to scratch the fuser belt. Lay
the fuser belt on the clean place to prevent
the belt from the dust.
Fig. 16-28
(3) Remove 1 screw and take off the bracket on
the front side.
Fig. 16-29
(4) Remove 1 screw and take off the bracket on
the rear side.
Fig. 16-30
Fuser belt unit
Bracket
Screw
Bracket
Screw
To Next Page
Loading...
