Toshiba e-studio281c - Page 368

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FUSER UNIT / PAPER EXIT SECTION
16 - 26
(5) Remove 1 E-ring. Then remove 1 bearing.
Fig. 16-31
(6) Lift up the separation roller by sliding it.
(7) Take off the fuser belt.
Fig. 16-32
Note:
When installing the fuser belt, place a sheet
of paper between the separation plate and
fuser belt in order to prevent the fuser belt
from being scratched by the separation plate.
Keep the paper between then until the fuser
roller is installed.
Fig. 16-33
Bearing
E-ring
Fuser belt
Separation roller
Fuser belt
Peper