16
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16 - 29
[I] Thermostat (THMO1)
(4) Remove each 1 ring, 1 bearing and 1 bush-
ing on both front and rear sides of the pres-
sure roller.
Fig. 16-40
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Remove 2 screws. Lift up the cleaning unit
and take it off.
Note:
When installing, fit 2 protrusions on the bot-
tom of the cleaning unit into the holes of the
frame securely.
Fig. 16-41
(3) Release the harnesses from the harness
clamps.
(4) Remove 2 screws and take off the thermo-
stat unit.
Note:
Be careful not to scratch the fuser belt.
Fig. 16-42
Pressure roller
Bushing
Bearing
Ring
Cleaning unit
Fuser belt
Thermostat unit
Screw
To Next Page
Loading...
