e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 48
(5) Remove 1 screw and the ground wire, and
then disconnect 2 connectors (3 if the
optional damp heater is installed).
Fig. 2-86
(6) Remove 2 screws and take off 2 fixing brack-
ets on the rear side.
Fig. 2-87
(7) Take off the lower drawer of the equipment
and PFP upper drawer.
Fig. 2-88
Fixing bracket
To Next Page
Loading...
