Toshiba e-studio281c - Page 72

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 52
[D] MJ-1022 (Hanging finisher) <When PFP/LCF is not installed>
(9) Remove 4 screws and take off 2 fixing brack-
ets on the front side.
Fig. 2-98
(10) Lift up the equipment and take off the LCF.
Fig. 2-99
(1) Turn OFF the power and unplug the power
cable.
(2) Take off the connector cover and disconnect
the connector.
Fig. 2-100
Fixing bracket
Fixing bracket
Connector cover