2
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
OUTLINE OF THE MACHINE
2 - 65
(3) Open the front cover of the hole punch unit.
Push the 2 latches and take off the hole
punch unit front lower cover.
Fig. 2-137
(4) Open the finisher front cover. Remove 1
screw and pull out the fixing plate.
Fig. 2-138
(5) Loosen 1 screw and take off the groune wire.
Fig. 2-139
Front lower cover
Fixing plate
06/07
To Next Page
Loading...
