Toshiba e-studio281c - Paddle Motor Abnormality; Communication Error between Finisher and Puncher Unit; Punch Communication Error

e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 84
[CDE0] Paddle motor abnormality
[CE00] Communication error between finisher and puncher unit
[CE00] Punch communication error
* You receive a [CDE0] error when the [ED15] error occurs three times in succession or during
the initial operation.
MJ-1101
Is there any mechanical problem with the paddle is rotated?
È
ÆYES Fix the mechanism.
NO
Is the harness between the paddle motor (M8) and the finisher control PC board (CN6) discon-
nected or open circuited?
l
È
ÆYES • Reconnect the connector securely.
• Replace the harness.
NO
1) Replace the paddle motor (M8).
2) Replace the finisher control PC board.
MJ-1023/1024 (When MJ-6004 is installed)
Is the problem solved by turning OFF and ON the power of the equipment?
È YESÆ End.
NO
Is the wiring between the finisher controller PC board and punch controller PC board correct?
È NO Æ Correct the wiring.
YES
1) Replace the finisher controller PC board.
2) Replace the punch controller PC board.
MJ-1101 (When MJ-6101 is installed)
Is the harness between the hole punch control PC board (HP) and the finisher control PC
board disconnected or open circuited?
È
ÆYES Replace the harness. Correct the wiring.
NO
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short cir-
cuited?
È
ÆYES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
06/08