Toshiba e-STUDIO283 - e-Filing Feature Setup Flows

© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 49
2
367 RADF RADF original guide width
adjustment
(Minimum)
ALL - - Stores the current width
of RADF original guide
by keying in this code
with the guide set at the
minimum width. Perform
this adjustment when the
RADF board or volume is
replaced, or when the
code (05-356) is per-
formed.
6
368 RADF RADF original guide width
adjustment
(Maximum)
ALL - - Stores the current width
of RADF original guide
by keying in this code
with the guide set at the
maximum width. Per-
form this adjustment
when the RADF board or
volume is replaced, or
when the code (05-356)
is performed.
6
401 Laser Fine adjustment of polygo-
nal motor rotation speed
(adjustment of primary
scanning direction repro-
duction ratio)
PRT 136
<0-255>
M When the value
increases by “1”, the
reproduction ratio of pri-
mary scanning direction
increases by approx.
0.07%. (approx. 0.1 mm/
step)
1
405 PPC 134
<0-255>
M1
410 Laser Adjustment of primary
scanning laser writing start
position.
PPC 128
<0-255>
M When the value
increases by “1”, the writ-
ing start position shifts to
the front side by approx.
0.0423 mm.
1
411 PRT 153
<0-255>
M1
421 Drive Adjustment of secondary
scanning direction repro-
duction ratio
(fine adjustment of main
motor speed)
PPC/
PRT
129
<0-255>
M When the value
increases by “1”, the
reproduction ratio of sec-
ondary scanning direc-
tion increases by approx.
0.04%.
1
422 FAX 139
<0-255>
M1
424 Drive Fine adjustment of exit
motor speed
PPC/
PRT
160
<0-255>
M When the value
increases by “1”, the
rotation becomes faster
by approx. 0.05%.
1
425 FAX 121
<0-255>
M1
Adjustment mode (05) <e-STUDIO200L/230/230L/280>
Code
Classi-
fication
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Proce-
dure
04/09