Toshiba e-STUDIO283 - Page 282

e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
12 - 12
[E] Auto-toner sensor
[F] Drum thermistor
(1) Remove the developer material
( P.12-10 "[C] Removing developer mate-
rial").
(2) Place the developer unit upside down. Dis-
connect 1 connector, remove 1 screw, and
then take off the auto-toner sensor.
Fig. 12-14
(1) Remove the developer material
( P.12-10 "[C] Removing developer mate-
rial").
(2) Disconnect 1 connector, remove 1 screw and
take off the drum thermistor.
Fig. 12-15
Connector
Auto-toner sensor
Connector
Drum thermistor