Toshiba e-STUDIO347CS - Setup Via USB (Windows)

Preparations to print from Windows
- 15 -
1
2
3
4
5
6
(5) Select [Internet Protocol Version 4 (TCP/
IPv4)] and click [Properties].
(6) Enter the numbers for the IP address,
subnet mask, default gateway, and DNS
server, and click [OK].
Memo
• If an IP address is to be obtained automatically
from a DHCP server, select [Obtain an IP address
automatically] and do not enter an IP address.
• Do not enter numbers for the default gateway and
DNS server if they are not being used.Close
[Local Area Connection].
(7) Close [Local Area Connection].
3
Configure the IP address and other settings
of the machine.
Memo
• For instructions on how to make settings for your
machine, refer to the Advanced Guide.
4
Turn the power to the machine ON, check
that Windows has started, and load the
"Client Utilities/User Documentation DVD"
supplied with the machine.
Follow the on-screen instructions for installation. For
details, refer to the Software Installation Guide.
Note
• If Software Installer does not automatically start, use the
Explorer to open the "e-STUDIO" folder in the Client
Utilities/User Documentation DVD and double-click
"Setup.exe".
Setup via USB (Windows)
For instructions on how to install the printer driver for USB
printing, refer to the Software Installation Guide.