Toshiba e-STUDIO347CS - Page 78

PRINTING FROM UNIX/Linux
- 78 -
2
1
3
4
5
6
7
Banner Paper Source
The banner paper source can be specified using the following
option.
If the banner paper source is not specified the PCL5e auto
paper source command “<esc>&l7H” will be sent. The banner
page source cannot be set to manual feed. The paper size
always has priority over the paper source.
Example: The command to specify that the banner page paper
source is the Large Capacity Feeder is “lp -o blcf <filename>”.
Banner Media Type
The banner page paper source can also be selected using the
media type using the following option.
The paper size always has priority over the media type and the
paper source.
If this option is not specified, the command will not be sent so
the printer’s default value will be used to print the banner page.
The command to specify that the banner page should be
printed on a media type is “lp -o bmtype=Plain1 <filename>”.
Option Value Alternate Value Description
bauto-source Select the auto paper tray
selection.
bdrawer1 bupper
bcas1
Select the 1st drawer.
bdrawer2 blower
bcas2
Select the 2nd drawer.
bdrawer3 bpedupper
bcas3
Select the 3rd drawer.
bdrawer4 bpedlower
bcas4
Select the 4th drawer.
blcf BLCF Select the Large Capacity
Feeder. The Large
Capacity Feeder is not
available for some
countries or regions.
Option Value Alternate Value Description
bmtype=Plain A paper source that
contains Plain paper is
requested.
bmtype=
Transparency
A paper source that
contains transparency
slides is requested.
bmtype=Thick1 A paper source that
contains Thick1 paper is
requested.
bmtype=Thick2 A paper source that
contains Thick2 paper is
requested.
bmtype=Thick3 A paper source that
contains Thick3 paper is
requested.