e-STUDIO350/450 DRUM RELATED SECTON 11 - 14 November 2003 © TOSHIBA TEC
11
[H] Toner bag full detection sensor
(H-1) Toner bag full detection sensor-1
(1) Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Take off the registration clutch and gear unit
( Chapter 10.4 [B][C]).
(3) Disconnect 1 connector and remove 1 screw.
Then take off the toner bag full detection sen-
sor-1 with the whole bracket.
(3) Take off the discharge LED.
(4) Disconnect 1 connector and take off the toner
bag full detection sensor-1 from the bracket.
[G] Discharge LED
(1) Take off the developer unit and cleaner unit
(
Chapters 12.5 [A] and 11.6 [A]).
(2) Disconnect 1 connector and remove 1 screw.
Then take off the discharge LED unit.
Fig. 11-620
Fig. 11-621
Fig. 11-622
Fig. 11-623
1
2
To Next Page
Loading...
