November 2003 © TOSHIBA TEC 11 - 15 e-STUDIO350/450 DRUM RELATED SECTON
11
(H-2) Toner bag full detection sensor-2
(1) Open the front cover.
(2) Disconnect 1 connector and take off the toner
bag full detection sensor-2.
[I] Developer unit cooling fan
(I-1) Developer unit cooling fan-2
(1) Take off the rear cover ( Chapter 2.5.1 [C]).
(2) Take off the SYS board with the whole case
( Chapter 2.5.2 [C]).
(3) Disconnect 1 connector and release the har-
ness from 1 harness clamp.
(4) Remove 2 screws and take off the duct.
Fig. 11-624
Fig. 11-625
Fig. 11-626
Fig. 11-627
Developer unit
cooling fan-2
(5) Release the harness from 1 harness clamp.
(6) Remove 1 screw and take off the duct cover.
(7) Take off the developer unit cooling fan-2.
Note:
When installing, pay attention to the direction
of the wind from the fan.
To Next Page
Loading...
