November 2003 © TOSHIBA TEC 12 - 11 e-STUDIO350/450 DEVELOPMENT SYSTEM
12
Fig. 12-513
Fig. 12-514
Fig. 12-515
[D] Auto-toner sensor
(1) Discharge the developer material
(
Chapter 12.5 (B-1)).
(2) Disconnect 1 connector on the bottom of the
developer unit.
(3) Remove 1 screw and take off the auto-toner
sensor.
[E] Drum thermistor
(1) Discharge the developer material
( Chapter 12.5 (B-1)).
(2) Take off the front cover of developer unit
( Chapter 12.5 (C-1)).
(3) Remove 2 screws and take off the developer
sleeve cover.
(4) Remove 1 screw and take off the drum ther-
mistor.
To Next Page
Loading...
