e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 58
[C130] Upper drawer tray is abnormal (paper can be fed from the drawers other than upper
drawers)
[C140] Lower drawer tray is abnormal (paper can be fed from the drawers other than lower
drawers)
Does the tray go up? (Perform the output check in the test mode: 03-242/243)
|
|
|
|
|
|
|
|
È
NO Æ 1) Check if the connector of the tray-up motor is disconnected.
2) Check if the connector CN306 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the LGC board.
YES
Is the tray-up sensor working?
(Perform the input check in the test mode: 03-[FAX]OFF/[6]/[H], /[7]/[H])
|
|
|
|
|
|
|
|
|
È
NO Æ 1) Check if the connector of the sensor is disconnected.
2) Check if the connector CN305 on the LGC board is disconnected.
3) Check if the slit reaches the sensor.
4) Check if the connector pins are disconnected or the harnesses are open
circuited.
5) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
6) Replace the LGC board.
YES
1) Check if the conductor pattern on the LGC board is short circuited or open circuited.
2) Replace the LGC board.
To Next Page
Loading...
