© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
FIRMWARE UPDATING
6 - 73
6
(11) Select the data file to be updated and click the [OK] button. There are two data filing methods:
Selecting the multiple data files in a batch (select the folder where the files are saved) and select-
ing each data file individually.
• Selecting the multiple data files in a batch
a. Select “Download File Folder”.
b. Click the [Browse] button and select the folder where the files are saved.
• Selecting each data file individually
a. Select “File Name Conversion”.
b. Click the [Browse] button of each data and select the file. When “Generic Driver” is used,
Tip:
When selecting the multiple files in a batch, the name of the unselected data file (not saved in the
folder) may be displayed. In this case, click the [OK] button and then the update of all files except
the displayed file starts.
To Next Page
Loading...
