14 - 17
14
e-STUDIO350/352/353/450/452/453
AUTOMATIC DUPLEXING UNIT
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
(5) Remove 4 screws and take off the bracket.
(7) Remove the clip on the front side.
(8) Remove 2 bushings and take off the upper
transport roller.
(6) Remove the clip, pulley, pin and belt on the
rear side.
Fig. 14-526
Fig. 14-527
Fig. 14-528
Screw
Bracket
Pin
Pulley
Belt
Clip
Clip
Bushing
Bushing
Upper transport roller
(4) Remove the screw and release the rear
latch.
Fig. 14-525
Screw
Rear latch
To Next Page
Loading...
