Toshiba e-STUDIO453 - Relation Between System Configuration And Ih Output

13 - 7 e-STUDIO350/352/353/450/452/453
FUSER UNIT / PAPER EXIT SECTION
13
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
13.4.4 Relation between system conguration and IH output
e-STUDIO350/450
* RADF: Reversing Automatic Document Feeder, FIN: Finisher, HPU: Hole Punch Unit,
LCF: Large Capacity Feeder, FAX: FAX unit
(*1) The wattage lowers 50 W more when the scanning is performed from the RADF during warming up.
(*2) AC power should be input voltage when the equipment is warming up (The lower the voltage is,
the longer the warming up time becomes).
e-STUDIO352/353/452/453
07/11
Systemconguration Warming up
(*2)
Ready Printing
Energy Saving
Mode
Automatically
OFF
Equipment only
1240-1200W
700W 980W OFF OFF
Equipment and
RADF
(*1)
Equipment, RADF
(*1)
and FIN
1220-1140W
Equipment, RADF
(*1)
,
FIN, and HPU
Equipment, RADF
(*1)
,
FIN, HPU and LCF
1160-1080W
Equipment, RADF
(*1)
,
FIN, HPU, LCF and
FAX
Systemconguration Warming up
(*2)
Ready Printing
Energy Saving
Mode
Automatically
OFF
Equipment only
1300-1200W
700W 980W OFF OFF
Equipment and
RADF
(*1)
Equipment, RADF
(*1)
and FIN
1280-1180W
Equipment, RADF
(*1)
,
FIN, and HPU
Equipment, RADF
(*1)
,
FIN, HPU and LCF
1260-1160W
Equipment, RADF
(*1)
,
FIN, HPU, LCF and
FAX