Toshiba e-Studio477s - Using the Bypass Tray; Open the Bypass Tray Forward; Pull Out the Paper Support; Unfold the Sub Support

- 65 -
How to Load the Paper
1
2
4
5
6
3
Using the Bypass Tray
Use the bypass tray when you want to print on
plain paper, postcards, envelopes, OHP lm,
or labels. The side you want to print on should
be placed face up. After loading the paper,
congure its size, type, and thickness by using
the operator panel.
1
Open the bypass tray forward by
inserting your ngers into the front
recesses.
Bypass tray
Front recesses
Front recesses
2
Pull out the paper support by
holding the center part of it.
Paper support
3
Unfold the sub support.
Sub support
4
Open the paper set cover.
Paper set cover
5
Adjust the manual feeding paper
guide to the width of paper to be
loaded.
Manual feeding
paper guide
6
Insert the paper with the print side
face up.
Note
•
Do not load paper exceeding the [

] mark.
[] mark
7
Close the paper set cover.
Paper set cover
“Zoom” screen is automatically displayed on the
touch panel.