The larger the value, the darker the image of the
area surrounding the target area becomes.
Amount of surrounding void
When the value increases, the blank area around
the scanned image becomes wider. (e.g.: In
network scanning with 600 dpi, if the setting value
is "1", the blank area increases by 1 dot.)
The larger the value, the darker the image at the
center value becomes.
Manual
adjustment/Center
value
The larger the value, the lighter the image at the
center value becomes.
Manual
adjustment/Center
value
The larger the value, the darker the image at the
center value becomes.
Manual
adjustment/Center
value
The larger the value, the darker the image
becomes.
Automatic density
adjustment
The larger the value, the darker the image
becomes.
Automatic density
adjustment
The larger the value, the more the original tends to
be judged as a blank page.
Blank page
judgment
threshold
adjustment
The larger the value, the more the original tends to
be judged as black even in the auto color mode.
The smaller value, the more it tends to be judged
as color.
This code is used to change the width of fine lines
in PS and PDF printing. Automatic stroke
adjustment is the function that prevents the width
from changing according to the position.
This code sets whether automatic stroke
adjustment is enabled or disabled if it is not
included in the print data. If this setting is disabled,
there will be an increase in cases in which the
width of fine lines becomes thicker by 1 dot when
they are printed.
0: Disabled
1: Enabled
2: Forcibly disabled (Ignores command in printing
data)
3: Forcibly enabled (Ignores command in printing
data)
PS/PDF
automatic stroke
adjustment
To Next Page
Loading...
