1.General Adjustments – Copying, Printing and e-Filing (Output from Box)
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC © 2018 TOSHIBA TEC CORPORATION All rights reserved
1-22
*8.When the number of times in the Full Mode increases, more toner is consumed.
*9.When the Full Mode and the Short Mode are set simultaneously, the former has a priority.
If you never want to start the Short Mode, set “1” (Disabled) to code 08-2495. (0: Enabled)
<Notes>
• Set the value in consideration of users’ requests and the total number of pages output in a day. To
maintain the optimal image quality, it is recommended to start the Short Mode at least two or three
times a day.
• Do not set the number of output pages smaller than 50 for codes 08-2509 and 08-9199 because
this affects the life of consumables such as a cleaning blade.
• Changing this setting improves the stability of the image quality. However, a long application of
this change affects the life of consumables. It is recommended to make only a minimal change
and then return to the default value immediately.
(C). To stabilize the image quality on Low/Middle density in pictures (when interrupting jobs and
starting the Full Mode at every 250 pages)
Code to set
number of
pages
Setting
value *8
Starting conditions
Full IQC 08-2509 250 The control starts after every 250 pages.
Short IQC 08-2497 100
The control starts after 50 pages have been output, or
when a job is interrupted after every 250 pages.
Printing
interrupted
08-9199 250
(D). To emphasize performance (for less use of the Short Mode)
Code to set
number of
pages
Setting
value *9
Starting conditions
Full IQC 08-2509 1000 The control starts after every 250 pages.
Short IQC 08-2497 500
The control starts only when a job is interrupted after 500
pages have been output.
Printing
interrupted
08-9199 1000
To Next Page
Loading...
