5
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 CONTROL PANEL
5 - 7
60 Cannot use AMS mode Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Set the reproduction ratio 200% or
below manually
61 More than 200% is not
available
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Set the reproduction ratio 200% or
below
62 Updated the template set-
ting
Displayed when the template stored
is recalled by pressing [TEMPLATE]
button
63 Enter Department Code Displayed when a button is pressed
while the department management
setting is available
64 Cannot copy
Check DEPARTMENT
COUNTER
Displayed when the number of print-
outs exceeds the limit number of
department counter
65 Select the same sized Tab
sheets as the originals
Displayed when the paper sizes for
the tab sheets and originals are dif-
ferent
Select the same size for tab sheets
and originals.
66 Select the same sized
Inserter sheets as the origi-
nals
Displayed when the paper sizes for
inserter paper and original are differ-
ent
Select the same size for the inserter
sheets and originals.
67 Set Tab sheets in the same
direction as the originals
Displayed when the paper directions
for tab paper and original are differ-
ent
Set the tab sheets in the same direc-
tion as the originals.
68 Set Inserter sheets in the
same direction as the origi-
nals
Displayed when the paper directions
for inserter paper and original are dif-
ferent
Set the inserter sheets in the same
direction as the originals.
69 Only one paper source can
be used with Cover Sheet
feature
Displayed when both the cover sheet
mode and inserter cover sheet mode
are selected
Release either the cover sheet mode
or inserter cover sheet mode.
70 Only two paper sources
can be used with Sheet
Insertion feature
Displayed when all the sheet inser-
tion mode, tab insertion mode and
inserter sheet insertion mode are
selected
Release any of three modes
71 ADD PAPER TO
INSERTER FEEDER
Displayed when the inserter mode is
valid and the [START] button is
pressed without papers on the tray
• Release the inserter mode
• Set papers on the inserter tray
72 Set the paper source for
Tab sheet
Displayed when the tab paper mode
is valid and the tab drawer is not
selected
Select the 2nd drawer property to the
tab to release this state.
73 Fuser cleaning web
decreased
Displayed when the fuser unit clean-
ing web gets decreased
* This message is set not to be dis-
played at shipment, but the set-
ting can be changed at the setting
mode (08-941).
Replace the cleaning web.
74 Time for periodic mainte-
nance
(Fuser cleaning web)
Displayed when the fuser unit clean-
ing web gets run out
Replace the cleaning web.
75 Tab size: A4/LT only Displayed when the tab paper mode
is valid and other than A4/LT is
selected for the tab paper size
Select A4 or LT for tab paper.
76 Time for periodic mainte-
nance
PM cycle
• Displayed at the time for mainte-
nance
• Copying is available
Maintenance and inspection are per-
formed by qualified service techni-
cian
No. Message State of equipment Note
To Next Page
Loading...
