Toshiba E-STUDIO520 - Page 140

e-STUDIO520/600/720/850 SCANNING SECTION March 2005 © TOSHIBA TEC
6 - 16
[B] Lens cover
[C] Automatic original detection sensor (APS sensor) (S1 / S2 / S3 / S4 / S5)
(1) Take off the original glass
( P.6-15 "[A] Original glass").
(2) Disconnect 2 connectors.
(3) Remove 10 screws to take off the lens cover.
Fig.6-17
Fig.6-18
(1) Take off the lens cover
( P.6-16 "[B] Lens cover").
(2) Remove 2 screws to take off the remaining
APS sensor with its bracket.
Fig.6-19
A4 series
Connector
ConnectorLens cover
LT series
Connector
Connector
Lens cover