9
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 PAPER FEEDING SYSTEM
9 - 5
12)Drawer bottom sensor (S30, S36, S42, S48)
This sensor detects the tray bottom position of the drawer.
13)Tandem LCF tray bottom sensor (S71)
It detects the lower limit position (home position) on the LCF tray.
14)Standby side mis-stacking sensor (S72)
It detects if sheets of paper placed in the feeding side tray or standby side tray are not within the tray
(sheets are not aligned correctly).
15)End fence home position sensor (S73)
It detects the end fence home position.
16)Standby side empty sensor (S74)
It detects the presence/absence of a sheet of paper on the standby side tray.
17)End fence stop position sensor (S75)
The tandem LCF end fence motor (M42) drives the end fence. The end fence pushes a sheet of
paper placed on the standby side tray, and moves it to the feeding side tray. The end fence stop
position sensor (S75) detects the stopping position of the end fence so that the sheet is not pushed
too much.
To Next Page
Loading...
