Toshiba E-STUDIO520 - Page 227

10
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 PROCESS RELATED SECTION
10 - 11
[B] Wire cleaner drive unit / Wire cleaner drive motor (M12)
Note:
When assembling the main charger, install it
so that the charger wire passes through the
center of the pad.
Fig.10-12
(1) Take off the cleaner unit.
( P.11-7 "[A] Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the wire cleaner drive unit.
Fig.10-13
(3) Disconnect 1 connector, remove 1 screw,
and then take off the wire cleaner drive motor
(M12) with the bracket.
(4) Remove 2 screws and take off the wire
cleaner drive motor.
Fig.10-14
Cleaning pad
Charger wire
Cleaning pad
Charger guide
Main chargerCleaner unit
Screw
Screw
Screw
Wire cleaner drive motor