e-STUDIO520/600/720/850 PROCESS RELATED SECTION March 2005 © TOSHIBA TEC
10 - 12
[C] Discharge LED (ERS)
(5) Disconnect 2 connectors, remove 1 screw,
and then take off the wire cleaner position
detection switch (SW4).
Note:
Push the switch in the direction of arrow A to
fix it. Also, carefully insert the connector into
the terminal of the color of the harness, and
then bend the terminal 45 º.
Fig.10-15
(1) Take off the wire cleaner drive unit.
( P.10-11 "[B] Wire cleaner drive unit /
Wire cleaner drive motor (M12)")
(2) Disconnect 1 connector.
Fig.10-16
(3) Lift the connector side of the discharge LED
slightly to release the lock, and then slowly
pull out the discharge LED from the guide.
Note:
Assemble the discharge LED so that all fin-
gers of the guide are hooked.
Fig.10-17
ConnectorPurpleBlack
Screw
(
A
)
Connector
Discharge LED
Discharge LED
Latch
Lock pin
To Next Page
Loading...
