Toshiba E-STUDIO520 - Page 263

12
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 DEVELOPER UNIT
12 - 17
(2) Disconnect 1 connector to release the har-
ness from the clamp.
Fig.12-15
(3) Remove 2 screws to take off the inner cover.
(4) Remove 1 screw.
(5) Remove 3 screws to take off the toner drive
section.
Fig.12-16
(6) Disconnect 1 connector to release the har-
ness from the clamp.
(7) Remove 2 screws to take off the motor with
bracket.
Fig.12-17
Connector
Connector
Clamp
Cover
Drive unit
Bracket
Connector
Gear