Toshiba E-STUDIO520 - Disassembly and Replacement

e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT March 2005 © TOSHIBA TEC
13 - 6
13.5 Disassembly and Replacement
[A] Transfer unit
(1) Open the front cover and take out the trans-
fer/transport unit by turning the lever clock-
wise.
Fig.13-3
(2) Remove 1 screw to take off the handle.
(3) Remove 2 screws to take off the cover.
Fig.13-4
(4) Disconnect 2 connectors. (Raise the belt
when disconnecting the connector on the
right side.)
(5) Remove 1 clip and slide the bearing on the
front side to inside.
(6) Remove 4 screws.
(7) Slide the transfer unit to the rear side and
raise the front side to take it off.
Fig.13-5
Transfer/transport unit
Handle
Screw
ScrewScrew
Cover
Screw
ScrewScrew
Bearing Clip
Connector