Toshiba E-STUDIO520 - Page 285

13
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT
13 - 9
[D] Cleaning blade
[E] Transfer/Transport unit
(1) Take off the transfer unit.
( P.13-6 "[A] Transfer unit")
(2) Remove 3 screws to take off the cleaning
blade.
Fig.13-12
Notes:
1. When installing the blade, fix the boss on
both sides with the screws.
2. Be careful not to touch, scratch or dam-
age the blade.
3. After installing the blade, be sure that the
seals on both sides are not damaged.
Fig.13-13
(1) Take off the transfer unit.
( P.13-6 "[A] Transfer unit")
(2) Take off the fuser unit.
( P.14-18 "[B] Fuser unit")
Note:
Make sure to take off the fuser unit and
transfer unit before the transfer/transport
unit.
Fig.13-14
Cleaning blade
Screw
Cleaning blade
Urethan seal
Transfer/transport unit