e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT March 2005 © TOSHIBA TEC
13 - 12
[G] Horizontal transport section driving clutch-2 (CLT2)/ -3 (CLT3)
[H] Horizontal transport section driving clutch-1 (CLT1)
(1) Remove the transfer/transport unit.
( P.13-9 "[E] Transfer/Transport unit")
(2) Disconnect 1 connector and remove 1 E-ring
to take off the each clutch.
Fig.13-20
(1) Take off the transfer/transport unit
( P.13-9 "[E] Transfer/Transport unit")
(2) Disconnect 1 connector.
(3) Remove 1 E-ring and 3 screws to take off the
bracket.
Fig.13-21
(4) Take off the driving clutch from the shaft.
Note:
Fix the stopper of the clutch in the "R"
marked side.
Fig.13-22
Horizontal transport section
driving clutch-2
Horizontal transport section
driving clutch-3
E-ring
E-ring
E-ring
Bracket
Screw
Screw
Black
Horizontal transport section
driving clutch-1
To Next Page
Loading...
