13
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT
13 - 13
[I] Transfer belt drive motor unit / Transfer belt motor (M14)
[J] Transfer belt contact/release cam driving unit
Notes:
1. When fixing the clutch with the E-ring, be
sure that the one side of the E-ring latch
does not overlap the flat part of the shaft.
2. Be sure that the stopper of the clutch is
inserted into the groove of the bracket.
3. Make sure that the bearing and gear are
installed correctly.
Fig.13-23
(1) Take off the rear cover.
( P.2-47 "[L] Rear cover")
(2) Remove 3 screws to take off the flywheel.
(3) Disconnect 1 connector, and then remove 1
spring and 2 screws to take off the drive
motor unit.
(4) Remove 3 screws to take off the bracket.
(5) Remove 2 screws to take off the transfer belt
motor.
Note:
When installing the motor, fix it by rotating it
counterclockwise.
Fig.13-24
(1) Take off the rear cover.
( P.2-47 "[L] Rear cover")
(2) Remove 3 screws to take off the flywheel.
(3) Disconnect 1 connector and remove 2
screws to take off the cam driving unit.
Fig.13-25
E-ring
Connector
Screw
Screw
Spring
Transfer belt contact/release cam drive unit
Screw
To Next Page
Loading...
