e-STUDIO520/600/720/850 TRANSFER/TRANSPORT UNIT March 2005 © TOSHIBA TEC
13 - 14
[K] Transfer belt cam motor (M15)
(4) Remove 1 screw to take off the transfer belt
release detection sensor (S15).
(5) Remove 1 screw to take off the transfer belt
contact detection sensor (S16).
Fig.13-26
(1) Take off the transfer belt contact/release cam
driving unit.
( P.13-13 "[J] Transfer belt contact/release
cam driving unit")
(2) Remove 2 screws and disconnect 1 connec-
tor to take off the transfer belt cam motor.
Fig.13-27
Transfer belt release
detection sensor
Transfer belt contact
detection sensor
Transfer belt cam motor
To Next Page
Loading...
