Toshiba E-STUDIO520 - Page 308

e-STUDIO520/600/720/850 FUSER UNIT March 2005 © TOSHIBA TEC
14 - 18
[B] Fuser unit
(4) Disconnect 3 connectors and remove 6
screws to take off the IH board.
Fig.14-13
(1) Remove 2 screws and open the IH cover-1
carefully to the front side.
(2) Remove 2 screws to take off a knob cover.
Fig.14-14
(3) Remove 4 screws and then release 4 power
supply harnesses of the IH coil.
(4) Disconnect 4 connectors.
(5) Remove 2 screws and open the IH cover-2 to
the front side.
Fig.14-15
Connector
(
Yellow
)
Connector
(
White
)
Connector
Heater control PC board Screw
Screw
Screw
Screw
Knob cover
Screw
Connector
Connector
Screw
Screw
Screw
IH cover-2