14
March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 FUSER UNIT
14 - 19
[C] Cleaning web unit / Cleaning web
(6) Remove 1 screw, move the fuser unit for-
ward and lift it off upward.
Notes:
1. When installing or taking off the fuser unit,
grab the section "A" in the figure.
2. Be sure that the temperature of the fuser
unit has lowered enough before taking it
off. If the unit still heated should be taken
off, wear a pair of gloves before working.
3. Hold B sections of the fuser unit when
installing/removing it.
Fig.14-16
(1) Remove 2 black screws to take off the clean-
ing web unit.
Note:
The cleaning web unit can be taken off with-
out removing the fuser unit.
Fig.14-17
(2) Remove 4 E-rings. Then remove 4 bushings
to take off the cleaning web.
(3) Remove 1 E-ring, 1 bushing, 1 E-ring, 2
gears, 1 pin, and 1 bushing in order from the
shaft.
Fig.14-18
A
B
Screw
Screw
Cleaning web
E-ring
E-ring
E-ring
To Next Page
Loading...
