Toshiba E-STUDIO520 - Page 318

e-STUDIO520/600/720/850 FUSER UNIT March 2005 © TOSHIBA TEC
14 - 28
[I] Pressure roller
[J] Web detection sensor (S8)
(13) Take off the fuser roller covering it with paper
and such not to make scars on it.
Fig.14-39
(1) Take off the fuser roller
( P.14-26 "[H] Fuser roller").
(2) Take off the pressure roller with its bearing.
(3) Remove 2 bearings and 2 collars from the
pressure roller.
Fig.14-40
(1) Take off the fuser unit
( P.14-18 "[B] Fuser unit").
(2) Take off the cleaning web unit
( P.14-19 "[C] Cleaning web unit / Clean-
ing web").
(3) Take off the fuser unit front cover.
(4) Disconnect 1 connector and remove 1 screw
to take off the web detection sensor with its
bracket.
(5) Release the latch of the sensor to take off the
web detection sensor.
Fig.14-41
Fuser roller
Pressure roller
Web detection sensor
Screw