e-STUDIO520/600/720/850 FUSER UNIT March 2005 © TOSHIBA TEC
14 - 30
[L] Pressure roller thermistor (THM4)
(7) Disconnect 1 connector to take off the fuser
transport sensor.
Fig.14-45
(1) Take off the fuser unit
( P.14-18 "[B] Fuser unit").
(2) Disconnect 1 connector of the pressure roller
thermistor.
(3) Remove 2 screws to take off the lower
entrance guide.
(4) Remove 1 screw to take off the harness
cover.
(5) Remove 1 screw to take off the pressure
roller thermistor.
Notes:
1. Use tightening torques of 0.4-0.6 N
·m to
prevent the thermistors from damage.
2. Be sure that the thermistor is contacting
with the pressure roller when it has been
installed.
Fig.14-46
Fuser transport sensor
Harness cover
Pressure roller thermistor
To Next Page
Loading...
