e-STUDIO520/600/720/850 REVERSING AUTOMATIC DOCUMENT FEEDER (RADF) March 2005 © TOSHIBA TEC
16 - 14
6) Start of 1st original back side registering
The large original exit motor (M39) starts to rotate forward. After the large original exit sensor (S68)
has detected the leading edge of the original then the original has proceeded a specified distance
and been registered, the large original exit motor (M39) stops rotating.
Fig.16-24
7) Start of 1st original back side feeding
Both the large original exit and read motors (M39, M36) start to rotate forward, and when the leading
edge of the original has come to a specified distance before the read sensor (S69), they start to slow
down.
They stop to rotate when the leading edge of the original has reached the read sensor (S69) then
the original has been transported a specified distance by the read motor (M36). At the same time,
the original stop signal is set.
Fig.16-25
To Next Page
Loading...
