e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 80
[CB60] Stapler shift motor abnormality
Is the stapler shift home position sensor (PI7) working normally?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the stapler shift motor (M4) cor-
rect?
YES Correct the wiring.
NO
Is there any mechanical problem with the stapler stand motion path?
YES Fix the mechanism.
NO
Try replacing the staple shift motor. Is the problem corrected?
YES END
NO
Replace the finisher controller PC board.
To Next Page
Loading...
