5
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
CONTROL PANEL
5 - 13
(5) Take off the top right cove and right upper
cover.
( P.2-42 "[C] Top right cover",
( P.2-43 "[F] Right upper cover",
(6) Release the harness from the clamp.
(7) Remove 1 screw and take off the clamp.
Fig. 5-10
(8) Remove 3 screws.
(9) Release the harness from the clamp and
then place the control panel unit with its
reverse side up.
Note:
When assembling the unit, be sure that the
harness is not caught.
Fig. 5-11
(10) Take off 3 clamps and disconnect 1
connector.
(11) Remove 2 screws, take off a USB port and
then the control panel unit.
Fig. 5-12
Control panel unit
To Next Page
Loading...
