Toshiba e-studio555 - Page 247

11
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
DEVELOPER UNIT
11 - 15
[B] Toner recycle unit
[B-1] Toner recycle unit
(6) Disconnect 1 connector to release the
harness from the clamp.
(7) Remove 2 screws to take off the motor with
bracket.
Fig. 11-17
(8) Remove 2 E-rings and then 2 gears.
(9) Remove 2 screws to take off the new toner
transport motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 11-18
(1) Take off the toner cartridge drive unit.
( P.11-12 "[A] Toner cartridge drive unit")
(2) Remove 2 screws to take off the left inner
cover.
(3) Disconnect 1 connector, remove 2 screws,
and then take off the toner recycle unit.
Fig. 11-19
Bracket
Connector
Gear
New toner transport motor
Gear
Gear
Toner recycle unit
Connector