e-STUDIO555/655/755/855 © 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER/TRANSPORT UNIT
12 - 6
[B] Transfer belt
Notes:
1. Change the screw position before
performing the transfer belt deviation
adjustment.
For the adjustment procedure, refer to
"3.10 Transfer belt deviation adjustment"
in the SERVICE HANDBOOK.
2. When installing the transfer unit, make
sure that the lever comes under the cam.
Fig. 12-6
Fig. 12-7
(1) Take off the transfer unit.
( P.12-5 "[A] Transfer unit")
(2) Turn the transfer belt unit 90º and pull it out
upward.
Fig. 12-8
Screw
For adjustment
Default
Lever
Cam
Transfer belt unit
Transfer unit
To Next Page
Loading...
