13
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
FUSER UNIT
13 - 27
[I] Pressure roller
[J] Web detection sensor (S8)
(13) Take off the fuser roller covering it with paper
and such not to make scars on it.
Fig. 13-40
(1) Take off the fuser roller
( P.13-25 "[H] Fuser roller").
(2) Take off the pressure roller with its bearing.
(3) Remove 2 bearings and 2 collars from the
pressure roller.
Fig. 13-41
(1) Take off the fuser unit
( P.13-17 "[B] Fuser unit").
(2) Take off the cleaning web unit
( P.13-18 "[C] Cleaning web unit /
Cleaning web").
(3) Take off the fuser unit front cover.
(4) Disconnect 1 connector and remove 1 screw
to take off the web detection sensor with its
bracket.
(5) Release the latch of the sensor to take off the
web detection sensor.
Fig. 13-42
Fuser roller
Pressure roller
Web detection sensor
Screw
To Next Page
Loading...
